IDEAL Battery charger SMART CHARGER 8 LCD 6/12V 4/8A SMART8LCD

Technical Parameters

SMART CHARGE 8 LCD is an electronic charger for charging 6 and 12 volt lead-acid batteries:

WET (liquid - lead-acid)

GEL (gel)

MF (maintenance-free)

AGM (with fibreglass mat)

EFB (for vehicles with Start-Stop system)

The charger has a microprocessor control system, ensuring automatic shutdown when the required voltage is reached on the battery and automatic resumption of charging when the battery voltage drops.

Cold battery charging function: optimises charging at very low temperatures (low temperatures can adversely affect the chemical structure of battery components).

LCD Display

The chargers have a microprocessor control system and an LCD display which greatly facilitates monitoring and adjusting charging parameters.

Charging Process

9-step charging process ensures optimal charging conditions for the battery. The automatic control system adjusts each of the 9 charging steps for correct battery charging:

• STEP 1 - Diagnostic – analyses the battery and checks if it can accept charging current; prevents charging of a damaged battery
• STEP 2 - Recovery charge – low voltage batteries are initially charged with a small current but increased voltage; very discharged batteries can be restored to usability, ensuring longer battery life, the step is skipped if the battery is minimally discharged and in good condition.
• STEP 3 - Soft start – the charger gradually increases the charging current to reach the set charging current
• STEP 4 - Pulse charge – the battery is charged with a pulsed current (pulse fluctuations occur within the DC current range)
• STEP 5 - Reconditioning – preparatory stage for charging in the bulk charge stage
• STEP 6 - Bulk charge – charging with a constant current value to a previously set voltage (14.4÷14.7V)
• STEP 7 - Absorption charge – after reaching the required battery charge level, it switches to constant voltage charging (CV) and the charging process ends
• STEP 8 - Evaluation diagnostic - automatic monitoring of battery voltage after charging is completed
• STEP 9 - Maintenance charge – battery maintenance stage (float) and monitoring its condition; resumes charging with reduced current if necessary.

Physical Parameters

The charger housing has an IP 65 protection rating (splash-proof and dust-tight).

The device is equipped with protection: thermal, against sparking at the pole clamps, against pole short-circuit, overload, and reverse polarity.

Power Parameters

Single-phase power supply 230V. The device is equipped with a power plug.

Equipment

The delivery includes the device with cables. Power cable length 180 cm, pole cable length 180 cm.

Specification